Why do pipes burst when the ice thaws instead of when it freezes?
Ice can plug a pipe and hold the split closed. The break is under pressure from trapped water, but nothing flows until the ice melts. When the house warms, the plug goes and water pours through the split. That is why damage often shows up at the thaw, not during the cold.
A freezing pipe fails at the point where ice has grown and pushed against the metal or plastic, though the crack may be some distance from the ice itself. While the plug is solid, it acts like a cork. People see a dry floor and assume the pipe survived.
The practical lesson is to treat any pipe that stopped delivering water in a cold snap as suspect. If you know a line froze, shut the main valve before it thaws and check the length of it for a bulge or a split. A little caution at that point can mean the difference between a repair and a flooded room.
What should you do in the first minutes after a pipe bursts?
Shut off the main water valve, switch off power to any wet area only if you can reach the panel dry, and open a faucet at the lowest point to drain the lines. Move valuables away from the water, take photos, and call. Do not use a heat gun or open flame.
Closing the main valve is the single most useful act. Know where it is before you need it: in many homes it sits near where the water line enters the basement, close to the meter. A flooded floor with a live outlet is a hazard, so stay out of standing water if anything electrical is wet.
Photograph the water, the pipe and the walls before anything is moved. Date-stamped images support a claim and help the crew understand what happened first.
- Close the main shutoff valve and open the lowest faucet to drain the system
- Keep people and pets out of any room where water is near outlets or a bulging ceiling
- Lift small items off wet floors and put foil or plastic under furniture legs
- Photograph every wet surface and the failed pipe before touching it
- Do not pull up carpet or cut drywall before a technician has looked at it
Who repairs the pipe, and who dries the house?
A plumber repairs or replaces the pipe, and in New Hampshire plumbers are licensed through the Office of Professional Licensure and Certification. Manchester Water Damage Restoration does the drying and cleanup. The two jobs overlap, and the crew will work around the plumber so the leak is fixed before walls are closed.
New Hampshire has no statewide license for water damage restoration that we found, so this page does not claim one. The adjacent trades are different: plumbers and electricians are licensed through the state, and plumbing sits under the Mechanical Safety and Licensing Board. If a new line must be run or a panel is wet, those are the people to call.
Keeping the two jobs separate protects you. The restoration crew has no business soldering a joint, and a plumber has no business telling you a wall is dry. Each writes down what they did, and your insurer gets both sets of notes.
How is a pipe loss dried in an older house with plaster walls?
Plaster and lath dry slowly and often hold water behind a painted face. The crew uses moisture meters to read the wall rather than judging by the surface, opens small access points when readings stay high, and runs air movers and dehumidifiers until the wall comes down to its dry target.
Older Manchester houses can have plaster over wood lath, several paint layers, and walls that were built before modern vapor control. Water behind that finish can sit for days while the surface looks fine. The technician reads the wall at several heights, since water settles low and wicks upward.
Where plaster has soaked through and separated from the lath, it usually has to come off. Where it is only damp, drying through the room air may be enough. The decision is made from readings taken over successive visits, not from a guess on the first day.