Why is river flood water treated as contaminated?
River water carries sewage, runoff, oil and debris. In Manchester about 70 percent of the sewer system is combined, and overflows go to the Merrimack and Piscataquog rivers. So flood water is handled as contaminated, and porous materials it touched are usually removed rather than dried.
This is a water-quality fact about the city's sewer system and the rivers, not a claim about any particular home or street. It explains why the trade handles flood water with more caution than a burst pipe.
Drying alone does not clean a surface. After removal, the remaining hard materials are cleaned and treated before drying begins, so the structure is not left holding contamination in a dry state.
What has the Merrimack done to Manchester before?
In March 1936 the river rose to about 20 feet at Hooksett, and the Amoskeag dam in Manchester held after more than 500,000 sandbags were placed. In May 2006 it ran about 10 feet above flood stage in the city, and dozens of homes were flooded.
Those are the two floods this page draws on, and both come from published accounts of the 1936 and 2006 events. Block-by-block flood history for Manchester was not sourced, so this page does not say which streets took water.
History is not a forecast. It is the reason river levels deserve attention, and why the authorities, not a contractor, decide when a flooded area is safe to return to.
What should you do before the water goes down?
Stay out of flooded areas, keep power off to anything wet unless an electrician says it is safe, photograph the water line, and call. Do not run a wet vacuum or a heater in a flooded cellar. Leave pumping to the crew so the foundation is not stressed.
Move to higher ground and follow instructions from emergency officials. When the river falls, the first look inside should be quick and careful, with boots and gloves.
Photograph the water mark on every level and keep wet receipts and papers in a bag. Do not throw away damaged contents until they have been photographed.
- Do not enter a flooded cellar with live power or gas appliances
- Wear boots and gloves, and keep children and pets out of the water
- Photograph the water line and damaged items before they are moved
- Do not run a furnace or boiler that has been in contact with floodwater
Who handles the electrical and heating equipment after a flood?
Licensed trades handle it. In New Hampshire, electricians and plumbers are licensed through the Office of Professional Licensure and Certification. Equipment that was under water, such as a furnace, boiler or panel, should be inspected by the right trade before it is used.
A restoration crew removes the water and dries the structure; it does not certify a boiler or restore a panel. Naming the agencies is not an endorsement of any one company, and no statewide restoration license was found for the trade itself.
Keep your insurer informed. If a claim is handled badly, the New Hampshire Insurance Department's Consumer Services Unit takes complaints and mediates, though it cannot force a payout.