Why not just paint over a water stain on the ceiling?
A stain is a sign that water has been in the structure, not a cosmetic flaw. Stain-blocking paint hides the mark but leaves wet insulation and framing in the cavity, where mold can start and board can keep softening. The stain should be checked with a meter and the cavity opened first.
Paint seals a surface. It does nothing for the moisture behind it, and a ceiling painted too early can look sound for a month and then show a second ring. The paint film also traps moisture in the board, which slows drying. When a repainted stain comes back after the next storm, the cause is nearly always that the cavity above was never dried or the source was never fixed.
A moisture meter settles the question quickly. A reading on the stained board and on the board a foot beyond it tells the crew whether the water is old and dry or still present. A thermal camera adds a picture, because wet material holds a different temperature than dry material around it. Neither tool replaces looking inside, but together they show where to cut.
Can a wet drywall ceiling be dried in place, or does it have to come out?
Drywall that is only slightly damp and still firm can sometimes be dried in place. Board that has sagged, softened, crumbled or been wet with dirty water is cut out, because it will not regain its strength. The crew decides with a meter reading and a hands-on test, board by board.
Gypsum board is a paper-faced plaster sandwich. When the core stays wet, it loses strength, and the paper becomes a feeding ground for mold. The key signs that board must go are sag, soft spots that dent under a thumb, a swollen seam, or a stain that has returned. Board that has been wet for a long time is treated with more caution than board wet for a short time.
Insulation above a wet ceiling matters as much as the board. Loose-fill and batt insulation soak up water like a sponge, and once wet they stop insulating and keep the framing damp. They are usually removed along with the board, then replaced once the joists test dry.
What is different about plaster ceilings in older Manchester houses?
Plaster-and-lath ceilings are heavy, hold water longer than drywall and can fall in sections once the plaster loses its grip on the lath. Many Manchester houses predate 1940, so plaster is a real possibility. Wet plaster should be inspected before anyone stands under it.
Lath is a set of thin wood strips nailed across the joists. Wet plaster was pressed through the gaps between the strips to form keys, and those keys are what hold the ceiling up. Water softens the plaster, and sometimes also swells the lath, so the bond fails. A ceiling that sags a half inch in a single room can drop in a heap with no further warning.
Old buildings also carry old finishes. Paint, plaster additives and flooring from earlier decades can contain materials that call for care when they are disturbed. New Hampshire assigns asbestos abatement licensing to the Department of Environmental Services and lead abatement to the Department of Health and Human Services. Manchester Water Damage Restoration names those agencies so you know who to ask, and the crew stops and tells you if it sees something it cannot identify.
How do you find where the water in a ceiling is coming from?
Start with the room above the stain and the attic above that. Check fixtures, supply lines, the tub and the roof edge, then compare moisture readings across the area. A leak that appears only in rain or only in a thaw points to the roof; one that appears with water use points to plumbing.
Timing is the best clue. If the ceiling drips during a shower, the source is probably a drain, a tub seal or a supply line near that bathroom. If it drips only during or just after rain, look to flashing, a chimney, a vent pipe boot or a valley in the roof. If it appears in late winter when the snow is melting, an ice dam on the eave is the likelier cause.
When the cause is not obvious, the hidden leak detection page on this site explains how a crew traces slow leaks with meters and a camera. The goal is to leave with a name for the source, because drying a ceiling without fixing the source only sets up the next loss.