Phones answered 24/7Manchester, NH
Call (833) 490-5225
(833) 490-5225
Guide

Ice dams and ceiling leaks: what is happening and what to do

How an ice dam sends meltwater into a Manchester ceiling, what to do when it drips, what not to do on the roof and how to dry the attic and walls afterward.

Illustration for the guide "Ice dams and ceiling leaks: what is happening and what to do" (Manchester, NH)
Short answer

An ice dam is a ridge of ice at the roof edge that traps meltwater, which backs up under shingles and drips into the ceiling and walls. Contain the leak, relieve any bulging ceiling, keep off the roof, photograph the damage, and have the wet insulation and drywall dried.

Key takeaways

  • An ice dam forms when heat escaping into the attic melts snow on the roof, and the water refreezes at the cold eave.
  • Trapped meltwater can work under shingles and appear as a ceiling stain, a drip at a light fixture or a damp patch down an exterior wall.
  • A ceiling that bulges with trapped water is a collapse and electrical risk and should be opened in a controlled way.
  • Hacking at ice with a hatchet or climbing a snowy roof causes more harm than the leak does.
  • The visible stain is smaller than the wet area, because the water soaks attic insulation and runs down inside the wall.
  • The lasting fix is air sealing and insulation in the attic, not a heating cable alone.

What is an ice dam and why does it leak into the house?

It is a ridge of ice along the roof edge. Heat from the house warms the roof, snow melts, the water runs down to the cold eave and refreezes, and the ridge then holds back later meltwater that backs up under shingles.

The cycle begins inside the building. Warm air leaks from the living space into the attic through gaps around lights, hatches, chimneys and plumbing penetrations, and through thin insulation. That warms the roof deck above, so snow melts higher up the slope. The water runs down to the overhang, which is cold because it extends beyond the heated walls, and there it freezes into a ridge.

As the ridge grows, water behind it has nowhere to go. Shingles shed water downhill, but they are not designed to hold standing water, so it creeps up and under them, reaches the roof deck and finds a path through nail holes and joints. From there it wets insulation and drips onto the ceiling below. The leak often appears along an exterior wall, because that is where the eave and the attic floor meet.

Why does this happen in Manchester homes?

Southern New Hampshire gets the freeze-and-thaw cycle that builds ice dams, and older houses often have thin attic insulation and leaky ceilings that let heat escape to the roof. Both conditions are common here.

Contractor and public pages in New England list ice dams as a common winter cause of water damage in New Hampshire, and Manchester's housing stock helps explain why. A census-derived estimate suggests about 29 percent of the city's homes date from 1939 or earlier, with another quarter built from 1940 to 1969. Houses of those eras often have shallow attics, uneven insulation, old recessed fixtures and chimneys that were never sealed around the framing.

The Amoskeag worker housing districts, dating mostly from 1838 to 1882, are brick tenement blocks and overseer houses, often with flat or shallow roofs, parapets and internal gutters. A flat roof with a drain can also develop ice around the outlet. Each configuration has its own way of trapping water, so the right fix depends on how the roof drains, not on a single formula applied to every house.

What should I do first when the ceiling starts to drip?

Move belongings, put a bucket under the drip and stay out from under any bulge. Switch off power to fixtures in the wet area from a dry panel. Then photograph the damage and call for help.

Protect what you can. Slide furniture away, cover floors with plastic, and place a bucket or tub under the drip. If a ceiling is sagging or bulging with trapped water, do not stand beneath it. Water in a ceiling cavity can sit above a light fixture, and a fixture that is dripping or buzzing should be switched off at the breaker, provided the panel is dry and you are standing on dry ground.

A bulge can be released safely by poking a small hole at its lowest point with a screwdriver or similar tool, while standing to one side with a bucket below, so that water drains in a controlled way and the whole panel does not drop. That is a judgment call, and if you are unsure, call a crew. Photograph the stain, the bulge and the fixture before anything changes, because the record helps with insurance.

Should I chip the ice or climb up and shovel the roof?

No. Chipping ice with a hatchet or hammer damages shingles, and climbing a snowy, icy roof is dangerous. Use a roof rake from the ground for the lower snow, or call a professional.

Falls from roofs are a serious risk in winter, and ice makes any surface unpredictable. Even from a ladder, hitting ice at the eave can crack shingles, bend gutters and loosen flashing, leaving a roof that leaks more than it did. Metal shovels and picks gouge roofing. The ice is also holding itself in place, so a partial removal often leaves it re-forming in the next thaw.

A roof rake used from the ground can remove snow from the lowest few feet of the roof, which reduces the supply of meltwater. Anything more than that is work for a roofer with fall protection. Plumbers and electricians are licensed through the Office of Professional Licensure and Certification, but roofers are a different matter, so ask any firm about its insurance and how it protects the roof surface. A restoration crew handles the water inside, and a roofer deals with the roof.

How far has the water gone beyond the stain?

Usually further than it looks. Meltwater soaks attic insulation, runs down inside the wall cavity and spreads along framing. The ceiling stain marks where it found a way out, not the full wet area.

Insulation holds water like a sponge and dries slowly, especially when buried under more insulation. Water that enters at the eave can travel along rafters and across the top of the wall, then flow down inside it, wetting drywall or plaster from behind. A small ceiling stain may sit over a much larger area of wet material in the attic and wall.

That is why a moisture meter and, often, thermal imaging matter. A crew checks the ceiling, the wall below it and the attic, maps the wet area and decides what can be dried in place. Wet insulation is usually removed, because it will not dry in a closed space. In older houses with plaster on lath, the plaster may stay if it is sound, or may need to come off if it has loosened. The decision follows the readings and not a rule of thumb.

Can mold grow from a roof leak in winter?

Yes. Mold needs moisture and organic material, and wet attic insulation, roof sheathing and drywall provide both. A cold attic slows growth, but a slow leak that is left alone can still feed it.

Winter may suggest that cold weather prevents growth, but a ceiling, wall cavity or attic that stays damp for days or weeks can support it, and warmth returns in spring. Stains that spread, a musty smell in a bedroom or visible spots on rafters and sheathing are the signs. Left alone, growth can also spread to materials that were not originally wet.

Prompt removal of wet insulation and drying are the best prevention. If growth is found, it should be handled with containment and cleaning, and a household should not simply paint over it. Mold work has no state license sourced here, so ask a firm about its methods. Where old materials are disturbed, asbestos is regulated by the Department of Environmental Services and lead by the Department of Health and Human Services, and both are worth a check in an older house.

How is an ice dam leak dried and repaired?

Wet insulation and damaged drywall come out, the cavity is dried with air movers and dehumidifiers until readings are normal, and then ceilings and walls are repaired. The roof and attic cause is fixed separately.

Drying begins with removal of what cannot be saved, then opening or ventilating the cavity so that air can move across wet framing. Dehumidifiers pull moisture from the air, and readings are taken until framing and sheathing measure dry. Closing a ceiling before that point seals moisture in. Ask for readings in writing before drywall goes back, particularly for a ceiling beneath an attic.

Repair follows: new insulation, drywall or plaster patching, texture and paint. Keep the stages apart in your head, since the emergency stage, the drying stage and the rebuild stage can be handled by different people. If an insurance claim is involved, the New Hampshire Insurance Department's Consumer Services Unit accepts complaints and can mediate, though it cannot force a payout. Keep photographs, readings and invoices together.

How do I keep ice dams from coming back?

Seal the air leaks from the living space into the attic, add insulation, and make sure the attic is ventilated. Keeping the roof cold is the lasting fix, and a heating cable only manages the symptom.

Air sealing comes first: gaps around chimneys, lights, attic hatches, wiring and plumbing penetrations let warm air reach the roof. After those are sealed, insulation brings the attic floor up to a level appropriate for the climate, and ventilation at the eaves and ridge carries away what heat remains. An energy auditor or insulation contractor can find leaks with a blower door and an infrared camera.

Heated cables along the eave can create channels for meltwater, which helps, but they use power and do not address why the roof is warm. Clear gutters and downspouts in autumn so they are not full of ice later. Remove snow from the lowest part of the roof with a roof rake after heavy snowfall. For a flat or low-slope roof, ask a roofer about drain and outlet maintenance, since ice at a drain traps water in the same way.

Frequently asked questions

Is an ice dam covered by homeowner insurance?

Policies differ. Many cover sudden water damage inside the house from an ice dam, while excluding the cost of fixing the roof or the conditions that caused it. Read your policy and ask your insurer. If there is a dispute, the New Hampshire Insurance Department's Consumer Services Unit takes complaints and can mediate, though it cannot order a payout.

Will the ceiling stop leaking when the ice melts?

The dripping may stop, but the damage does not. Wet insulation, framing and drywall stay wet in a closed cavity, and mold can follow. The leak will also return with the next freeze and thaw if the cause is not fixed. Have the area checked with a moisture meter before closing anything up.

Is it safe to leave a bulging ceiling alone?

No. A bulge holds a quantity of water that can bring down the drywall or plaster suddenly, and it may sit above wiring. Keep out from underneath it. Releasing the water through a small hole at the lowest point, from a safe position with a bucket below, is standard practice, or a crew can do it.

Why does my flat-roofed brick building leak at the edge?

Flat and low-slope roofs drain through scuppers and internal drains that ice can block, so meltwater pools and finds seams or flashing. Older brick buildings with parapets are prone to this. A roofer should inspect the drains and flashing, while the water inside is dried by a restoration crew.

Can I just run a space heater to dry the ceiling?

Not safely. A portable heater near wet materials is a fire and shock hazard, and it dries the surface without removing moisture from the cavity above. Professional drying uses air movers and dehumidifiers and takes readings to confirm that the framing and sheathing are dry, which a heater cannot do.

Sources

  1. New Hampshire Insurance Department
  2. NH Office of Professional Licensure and Certification

This guide is general information for Hillsborough County homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.

Skip the guesswork. Call for a straight answer.

Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what help should cost.

Keep reading

More guides

WhatsApp