Shut off the water at the main valve, switch off power to any wet area if you can do it from dry ground, and open a faucet to drain what is left. Photograph everything before you move it, move belongings out of the way, and call a restoration crew and your insurer.
Key takeaways
- The main shutoff valve is the single most useful thing to know, and it should be found before the first freeze, not during a burst.
- Water running near light fixtures, outlets or a ceiling that is bulging is an electrical hazard, and power to that area comes off first if it is safe to do.
- Pipes in attics, basements and crawl spaces are the ones New Hampshire winters most often freeze, because those spaces sit outside the heated envelope.
- Photographs and a written list taken before cleanup are the record an insurance claim depends on.
- A pipe that has frozen but not yet burst is a warning, and thawing it slowly can prevent the failure.
- Wet drywall, insulation and flooring need drying quickly, since mold starts on materials left wet.
What is the first thing to do when a pipe bursts?
Stop the water. Close the main shutoff valve, then open a cold tap on the lowest floor to let the remaining water drain. Once the flow is stopped, the rest of the response can be done calmly.
Most of the damage in a burst-pipe loss is done by the volume of water that keeps coming after the break, so the main valve matters more than any other step. In many New Hampshire homes the main shutoff sits where the supply enters the basement or crawl space, often near the water meter, and it is usually a lever or a round wheel. Turning it fully closed cuts the supply to the whole house. If the pipe that burst serves only a fixture, there may be a smaller valve nearby.
After the main is closed, open a faucet at the lowest level to drain the pipes, and open one upstairs to let air in. If the water heater feeds the broken line, turn off its power or gas as the manufacturer instructs. Do not hunt for the valve in water that is deep enough to reach outlets or appliances. If you cannot reach it safely, call the water utility or a plumber from outside.
Is it safe to turn off the power when water is coming through the ceiling?
Only if you can reach the panel without standing in water and with dry hands. Water near light fixtures, outlets or a sagging ceiling is an electrical hazard, and if the panel cannot be reached safely, stay out and call for help.
Water that passes through a ceiling can reach wiring, fixtures and junction boxes, and it conducts electricity. If a ceiling is bulging with trapped water, it may also be close to collapse, so keep clear of the area beneath it. Switching off the breaker serving that part of the house reduces the danger, but only when the panel is in a dry location and you are standing on dry ground.
If power is off in the wet area, do not plug in extension cords there and do not run a portable heater in a damp room. Plumbers and electricians in New Hampshire are licensed through the Office of Professional Licensure and Certification, so that agency is the place to check a tradesperson's credentials if the loss involves rewiring or a repair to the plumbing. A restoration crew handles drying, and a licensed electrician decides when wet circuits are safe again.
Why do pipes freeze in Manchester houses?
Pipes freeze where they sit in cold spaces: uninsulated runs in attics, basements, crawl spaces and exterior walls. Southern New Hampshire winters supply the cold, and a house with a gap in its insulation supplies the pipe.
Manchester has a large stock of older houses, and the city's census-derived estimates suggest about 29 percent were built in 1939 or earlier, with a quarter more from 1940 to 1969. Older construction often has supply lines running through exterior walls, unheated porches, mill-era basements with stone foundations and crawl spaces with little insulation. Any of these can put a pipe in a place where winter air reaches it. Common causes also include a gap around a pipe where it passes through a wall, a vent left open, or heat turned down in a vacant room.
Water expands as it freezes, and it is often the pressure between the ice plug and a closed faucet, not the ice itself, that splits the pipe. That is why a pipe can look fine when frozen and fail when it thaws. The leak begins to show only when ice melts and flow resumes, which is also why the burst is often discovered when someone returns to a house or when heat comes back after a power outage.
What do I do if a pipe is frozen but has not burst?
Keep the faucet open, find the frozen section and warm it slowly with a hair dryer or warm towels, working from the faucet toward the frozen part. Never use an open flame. If you cannot reach it, call a plumber.
A frozen pipe with no leak is a chance to prevent a loss. Open the nearest faucet so that water can flow as the ice melts and relieves pressure. Apply gentle heat to the pipe, beginning near the faucet and moving toward the blockage. A hair dryer, a heating pad or towels soaked in warm water all work. A blowtorch or any open flame can ignite framing or damage the pipe and should never be used.
If you cannot find the frozen section, or it is inside a wall, call a licensed plumber and keep the house heated. Check other taps, because one frozen pipe often means others are cold as well. Once the flow returns, look along the length of the pipe for drips or damp spots, since a crack may leak only after thawing. If water appears, treat it as a burst and close the main valve.
What should I photograph and document before cleaning up?
Take wide and close photographs of every wet room, the burst pipe, damaged belongings and the ceiling, floor and wall damage, before moving anything. Write a list and keep receipts for emergency costs.
Insurance claims depend on records made at the time. Photograph each room from the doorway, then close up on the wet surfaces, the failed pipe and any damaged furniture, electronics or flooring. A narrated video walk-through is quick and effective. Note when you discovered the leak, when you closed the main and what you did next. If you are away from the home, record the date you returned.
Keep damaged items until the adjuster has seen them or approved disposal, unless they are a health risk. Do not throw away the burst section of pipe, since it shows the cause. Save invoices for the plumber, equipment and any temporary lodging. If a dispute with an insurer arises, the New Hampshire Insurance Department's Consumer Services Unit takes complaints and can mediate, though it cannot order a payout. Having a clean set of records makes any conversation shorter.
What can I do myself, and what needs a crew?
You can stop the water, move belongings, remove standing water with towels or a mop and open doors and cabinets for airflow. Extraction, drying wall cavities and checking for hidden moisture need professional equipment.
Within the first hour, lift furniture off wet carpet, put foil or plastic under legs that rest on floors, take rugs and loose items to a dry room, and soak up what you can reach. Open cabinet doors and move wet items away from walls so air circulates. Keep the heat on at a moderate level, since warm air holds moisture that a dehumidifier can then remove. Do not use a household vacuum on water.
What a household cannot do is find water that has gone into wall cavities, insulation, the space under flooring or the floor below. A crew uses moisture meters and thermal imaging to find it, extraction equipment to remove standing water from carpet and subfloor, and air movers and dehumidifiers to dry the structure. The point of this stage is to learn how far the water went, not to guess. If it is a plaster ceiling, the crew decides whether it can be saved or must be opened.
How quickly does mold follow a burst pipe?
Mold can start on damp materials within a few days if they stay wet. Removing standing water, taking out soaked insulation and drywall, and drying the structure promptly are what prevent it from taking hold.
A burst pipe in an attic or wall can soak insulation and framing that dry very slowly because they are enclosed. Water that has moved into a wall cavity does not dry on its own while the wall is closed. The visible stain on a ceiling is usually smaller than the wet area behind it. Pulling back a section of ceiling or wall to expose the wet material is not vandalism. It is how drying works.
If you smell must, see spreading discoloration or find spots weeks later, ask whether the structure was dried to readings. No state license for mold work is sourced for New Hampshire, so ask a firm how it contains and cleans growth. Asbestos abatement is regulated by the Department of Environmental Services and lead by the Department of Health and Human Services, which matters if an older house has to be opened up.
How do I stop this from happening again?
Insulate pipes in attics, basements, crawl spaces and exterior walls, seal gaps where cold air gets in and keep the heat on in a vacant house. Know where your main valve is and test it before winter.
Foam sleeves on exposed pipes, caulk or spray foam around penetrations, and insulation in a crawl space or rim joist are inexpensive measures that reduce the chance of a freeze. Disconnect and drain outdoor hose bibs before cold weather. Open cabinet doors on exterior walls during a hard freeze so room air reaches the pipes behind them. In very cold weather, a slow trickle from a faucet on an exposed line keeps water moving.
If a house will be empty, a seasonal property for example, set the heat to a safe minimum and have someone check on it. Many burst-pipe losses happen in homes that were left cold. Some owners drain the system entirely. Whatever you choose, test the main shutoff valve once a year so that you know it turns when you need it, since old valves can seize.
Frequently asked questions
Where is the main water shutoff in an older Manchester home?
Usually where the supply line enters the house, often in the basement near the meter or at a front wall. In older homes it may be a gate valve with a round wheel, which can stick if it has not been turned in years. Find it and turn it before winter, so you know it works.
Should I call my insurer or a restoration company first?
Stop the water first. After that, call both, in whatever order is practical. A restoration crew can start extraction and drying, which reduces the damage, and your insurer can explain what documentation is needed. Photograph the damage before work begins, and keep a record of who you spoke to and when.
Can I thaw a frozen pipe with a torch?
No. Open flames can ignite framing and insulation inside walls, and heat applied too quickly to a damaged pipe can make it fail. Use a hair dryer, heating pad or warm towels, starting near the open faucet. If you cannot reach the frozen section, a plumber should handle it.
Does water damage from a burst pipe mean the whole ceiling must come down?
Not always. Whether a ceiling can be dried in place depends on the material, how long it was wet and what readings show. Plaster, drywall and insulation behave differently. A sagging or bulging ceiling is a safety concern and may need controlled opening to release trapped water.
What if the burst happened while I was away?
Water may have run for a long time, so more material is likely wet than appears. Close the main, photograph everything and call a crew promptly, since time wet drives the scope. Tell your insurer the dates you left and returned. Drying and moisture readings will show how far the water reached.
Sources
This guide is general information for Hillsborough County homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.